Just like for binding regular 90 degree corners, you will need to use straight grain fabric strips for binding 120 degree corners. The entire binding can be done by sewing machine – super FAST & EASY!
- Straight Grain Binding Strips
- Marking Utensil (I use heat-erasable FriXion pen)
- Sewing Machine
- Extension Table (optional)
Prepare Straight Grain Binding:
- Cut 2-1/2″ X WOF strips from fabric or use precut Jelly Roll strips
- Holding the strips perpendicularly with right sides together, sew them diagonally and trim off the corners, leaving a 1/4” seam allowance
- Press the seams open
- Fold the long binding strip in half lengthwise and press
Sew binding on the back of the quilt as follows:
Line up the raw edges of the binding with the quilt edge on the back. Leaving a 6”-8” tail at the beginning, sew towards the corner with a 1/4” seam allowance; mark a dot in the corner, 1/4″ away from the edges and stop at the marked dot with the needle down. Backstitch and finish off.
Align the next raw edge of the quilt with the ruler on the extension table (if available) or with the straight edge of the desk. Fold the binding away from the quilt and align the edge with the ruler (or the edge of the desk), then fold the binding towards the quilt and line up all edges.
Mark a dot in the corner, 1/4″ away from the edges. Start at the marked corner and sew towards the next corner. Repeat the process until you pass all corners.
Stop at least 6” before your starting point. Depending on the size of the project, you can leave up to 10″ space at the end. Trim the ends, overlapping them by 2-1/2” (the width of the unfolded strip). Holding the ends perpendicularly with right sides together, sew them with a diagonal seam. Fold the binding to to make sure it fits properly. Trim the corners, leaving a 1/4″ seam allowance. Press the seam open and sew the remaining part of the binding.
Sew binding on the front of the quilt as follows:
Fold binding to the front of the quilt and sew towards the corner. Stop approximately 2″ away from the corner and fold the binding in the corner. Sew to the corner until the needle hits the folded edge. Stop with the needle down and pivot. Continue sewing around the edge, passing corners in the same manner….and you are done!
My new Hexi Cacti pattern for making hexagon shape placemats with 120 degree corners will be released SOON, I hope you will come back to check it out 🙂